[Guide] Cammus C12 Wheel Base Manual Firmware Flashing

Hardware Discussion Wheel Base C12
1

Hello Everyone,

If you’re facing any software issue with the Cammus C12 then you can flash the latest firmware manually.

Here is the step by step guide on how to flash firmware manually on Wheel Base.

  1. Install the Latest Cammus app on your computer. Download Link
  2. Make sure you have rootdemo file in the installation location of cammus app.
  3. Press and Hold Res Button at the back and then using another finger press the Open Button and hold it for 3 - 5 seconds until you hear 3 beeps. This will make the wheel base enter DFU mode.
  4. Open rootdemo file.
  5. Press on 2 dots button and Select the correct dfu file according to your wheel base.
  6. Press Flash Firmware button.

Here is the step by step guide on how to flash firmware manually on Wheel Hub.

  1. Install the Latest Cammus app on your computer. Download Link
  2. Make sure you have rootdemo file in the installation location of cammus app.
  3. Press and Hold the L5 button on the front of the base and then using another finger press the Power Button and hold it for 3 - 5 seconds until you hear 3 beeps. This will make the wheel base enter DFU mode.
  4. Open rootdemo file.
  5. Press on 2 dots button and Select the correct dfu file according to your wheel hub.
  6. Press Flash Firmware button.

If you get an error like No DFU Device Found then you need to close all the applications and power off the wheel base and start again.

Please watch this video to understand better. NOTE: This video shows the process on C5 but the process is the same for C12 except the keys used to enter WHEEL HUB DFU Mode

If you’re still not able to flash the firmware then please take a video and send it to us, so we can help you further.

Happy Firmware Update :wink: