Inverse mount for LC100 Pedals? - Load Cell cable is too short

[derodge]

I am wanting to inverse mount the LC100 pedal. I was able to mount them .

However, The Load Cell cable connector is too short to connect to the Brake cable to the control box.

The control box is on the right-side. When you move the Throttle to other side the cable will not reach.

1. Does anyone know of any other solution beside cutting the cable.

2. I can DIY or source a female to male cable. But, I need to know what kind of connector the current Load Cell cable uses.

I just know it’s a four-pin connector but I do know what size or type to look for.

[cammusracing]

Hi derodge,
Regarding the sensor extension cable you mentioned, we recommend that you can purchase a VH3.96 4-pin male connector online.

This should allow you to extend the Load Cell cable without cutting it and properly connect it to the control box.
Hope this is helpful.